The Ferrocontrol DARC2 R18-35-07 with DE-SIR for Elumatec is the digital axis controller with resolver feedback of the 18 A power class (9 kW) from the Ferrocontrol DARC 2 system, version with safety relay insert DE-SIR. This version is parameterised for machines made by Elumatec. The controller drives a brushless servo motor and is fed with the DC link voltage by the DARC supply module.

For machine operators
If your window or profile machining centre reports a fault on an axis controller, you will find the type designation on the nameplate of the module. Tell us this designation and the machine type – Finke Maschinen supplies the matching replacement unit with the firmware and parameter sets belonging to your machine (Plug and Work). You swap the module without having to program or adjust anything yourself.

Safety relay insert DE-SIR
The controller is supplied with the safety relay insert DE-SIR fitted. Its relay contacts allow the axis to be secured against unintended start-up without switching off the mains voltage; the 7-segment status display is also provided.

Function within the DARC 2 system
The axis controller converts the DC link voltage supplied by the supply module (560 V DC) into the three-phase motor voltage for the synchronous servo motor and controls the speed and position of the axis. Up to eight axis controllers operate on one supply module and communicate via the DARC system bus. The resolver input is used for electronic commutation as well as speed and position feedback of the motor – the R version is intended for synchronous and asynchronous motors with resolver. A short-circuit-proof 28 V output switches the motor holding brake, and a PTC input monitors the motor temperature.

Technical data

• Type: DARC2 R18, digital axis controller with resolver 18 A / 9 kW
• DC link input voltage: 560 V DC (480 V to 650 V) from the DARC supply module
• Rated output current: 18 A rms; peak current 2 × rated current for max. 7 s, current limit adjustable via motor parameters
• Chopper frequency of the output stage: 2 × 8 kHz
• Motor feedback: resolver input (synchronous and asynchronous motors); input for PTC or temperature switch
• Outputs: 28 V / 1.6 A short-circuit-proof for holding brake, 28 V / 0.6 A freely usable; opto-isolated control inputs (28 V)
• Electronics supply: 24 V DC / 0.6 A (18 V to 28 V), external time-lag fuse required
• Power loss: 15 W with output stage blocked, up to 210 W at rated load
• Cooling: fan; ambient temperature 0 °C to 45 °C; storage −25 °C to 55 °C
• Insert card: with safety relay insert DE-SIR
• Dimensions (W × H × D): 88 × 400 × 340 mm, weight approx. 10 kg
• Protection class IP20; EMC class A for industrial plants to EN 61800-3

Used in Elumatec machines
In this version the DARC2 R18-35-07 with DE-SIR is equipped with the firmware and parameter sets matching the Elumatec machine type (Plug and Work). Please state the machine type and the designation from the nameplate with your inquiry.

Procurement from Finke Maschinen
The DARC2 R18-35-07 with DE-SIR is available from Finke Maschinen as a new device, a refurbished unit with warranty or a tested used part. Benefit from short delivery times, fair prices and expert advice from our Ferrocontrol and Eckelmann specialists.